Bell Laser LLC

With a fixed beam length from the laser to the part, there is rarely a need for beam alignment.  Further, the accuracy of the laser mode is best with fixed beam.  This small footprint machine uses a fixture to load and unload the parts quickly so the cycle time is very short.

Utilizing a combined high speed galvo mirror system mounted on an XY table, the molded parts are laser trimmed of flash.  This high speed process increases prodution in automation. Some buyers utilize robotics to position the molded part, laser trim, then unload trimmed parts and place in stacking trays for removal.

A 3000 watt laser powered a high speed laser cross cutter that cut kevlar and aramid at two meters per second.

Upgraded Haas Automation vertical machining center to include high power laser cutting.

Custom laser machine to handle rolled material and laser cut on automotive production line.

The buyer wanted to increase the laser perforation rate on their paper products in the production line. Our lab setup a 1500 watt laser and successfully demonstrated laser perforation at 6 meters per second.

A large automobile manufacturer's R&D department requested laser samples for a Concept Car to be demonstrated in Europe. The laser etched samples reflect light to improve automotive headlight performance.

Our company laser cut titanium samples and demonstrated an improvement in edge quality over traditional machining methods.

Using a CO2 laser and a specialized optic for welding, plastic fabric was welded in order to replace traditional hot wire cut and weld techniques.

As a noncontact cutting device, laser cutting can replace knife trimming thus increasing yield on continuous web products. In this example, the traditional knife cutting pulled at the web, so the knife position needed to be a good distance from the actual web edge.  However, the laser applied negligable force when laser trimming so it was placed nearer to the edge of the web.  As the web product is sold by weight, the manufacturer increased yield by several percentage points.

aser trimming offers the advantages of smooth polished edges when trimming interior automotive parts.  This hexapod laser, also known as a drunken bar stool, uses parallel movement to precisely move the angled part for laser trimming.

Bell Laser provides trade-in re-imbursement on new laser machines (some conditions apply).  Below is a trade-in on a lower power laser for a higher power laser.  The trade in laser is a Coherent K-500 with power supply and chiller.